null

S&S 551 TWIN CAM KIT 06 Dyna and 2007-16 Big Twins 106-4858C

MSRP: $399.00
Was: $399.00
Now: $359.00
(You save $40.00 )
(No reviews yet) Write a Review

S&S 551 TWIN CAM KIT 06 Dyna and 2007-16 Big Twins 106-4858C

S&S Cycle 551C Chain Drive Cam Kit - 106-4858
  • Camshaft gear drive kits increase valve timing accuracy by eliminating timing chain lash and loosely fit stock chain drive
  • Reverses the rear cam's direction of rotation, providing additional operating clearance between cam lobes; as a result, higher cam lifts are possible with the gear drive kit
  • Kits include cams, inner gears, outer drive gears, inner and outer bearings, gasket and instructions
  • Material must be removed from the inner surface of the stock gear cover to install S&S gear drive cams
  • A hydraulic press and other professional-level tools are required to install these kits
  • S&S recommends that adjustable pushrod/cover kit PART #14-9988 be used
  • Cam bearings and gaskets must be replaced when installing new cams
  • Cams are also available with inner gears only; intended for cam replacement for motors that have already been converted to an S&S gear-drive system
  • Designed as bolt-in cam for touring bikes with compression ratio between 9:1 and 9:9
  • More power across the rpm range, with improved low and midrange torque
  • Can be used with stock pushrods, springs and lifters
  • Strongest from 1,000-4,000 rpm
  • Made in the U.S.A.

NOTE: Kits require high-performance valve springs (except 509G and 510G) when installed in 99-04 models

NOTE: Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance

NOTE: Due to the inherent characteristics of gear drives, you may experience more valve train noise

SPECS:

  • INTAKE OPEN:  17°
  • INTAKE CLOSE:  19°
  • INTAKE DURATION:  216°
  • EXHAUST OPEN:  41°
  • EXHAUST CLOSE:  17°
  • EXHAUST DURATION:  238°
  • LIFT: .550"


Included Items:

(1) Front camshaft

(1) Rear camshaft

(2) Small O-Rings

(1) Large O-ring

(1) Retaining ring

(2) 25x32x3 Needle bearings

(1) Cam cover gasket

(1) Tube Loctite 243

(1) Tube Loctite 262 

Instructions



The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.

Specifications
Mfg #: 106-4858
Part #: 1400124
Type Camshaft
Units Each
Weight 4.10 lbs
Alternate/OEM Part Number(s):
09250743
 
Harley-Davidson