• Independent dual look with hidden cross-over
• Hidden crossover passage between front and rear pipes for maximum performance
• Exclusive design moves the rear cylinder header away from passenger to reduce radiated heat
• Full Chrome or Hi-Temp Black ceramic heat shield with 220 degrees coverage
• Updated styling to give the bike a modern look
• Durable 16 gauge construction
• Spherical inlet design for improved sealing and exhaust gasket durability
• Compatible with 95-16 style slip-on mufflers
• FLHTCUTG 09-16 require adapter Part No. 4405604 to install
• Made in the U.S.A.

NOTE:

Includes both 12mm and 18mm sensor ports and plugs

Fitment note:

2010 Road Glide & Street Glide using OEM 2-1 Header require the purchase of mounting bracket (DK P/N 4405079) for left side muffler mounting

NOTES:
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information

There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See the CHEMS/LUBES section for products that will help prevent or remove bluing.

Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during or after installing their product. If a jet kit or fuel processor is recommended, see the FUEL/INTAKE section

(1) Stainless Steel header assembly

(1) Stainless Steel cross over pipe

(1) Chrome steel front heat shield

(1) Chrome steel rear heat shield

(1) Chrome steel cross over heat shield

(2) Exhaust gaskets

(1) Black steel mounting bracket

(1) "P" Style clamp

(1) "P" Style crossover clamp

(1) Transmission mounting bracket

(1) 44.5mm Accuseal band clamp

(8) #28 Hose clamps

(2) 18m O2 Plugs

(1) 3/8"-16 x 1-1/4" Carriage bolt

(2) 5/16"-18 x 3/4" Carriage bolts

(1) 3/8"-16 Serrated flange hex nut

(2) 5/16"-18 Serrated flange hex nuts

(4) 1/4"-20 x 1-7/8" Socket cap head bolts

Instructions

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.